19
EN
<Push fit Connector Type>
1
Firmly push the water tube connected from
the appliance into the end that has the
arrow pointing outward. Push the tube all
the way in (approx. 10-12 mm).
2
After inserting the tube securely into the
filter, fit the locking clip into position under
the pull up collar.
3
Repeat on the other end of the filter using
the remainder of the water tube.
Connecting to the Water Tap
1
Push the water tube into the hole of the tap
connector supplied in the accessories. The
pipe should be held firmly whilst the
connector is pushed onto the pipe.
2
Ensure that the rubber washer is fitted
inside to the inside of the tap connector
before screwing it onto the tap.
Checking the Water Connection
1
Turn on the water supply and switch on the
appliance. Carefully check all fittings for
possible leaks due to poorly fitted hoses.
2
Press and hold the Water Filter button for
three seconds. That resets the Replacement
Filter icon. The new water filter has been
activated.
3
Place a cup under the water dispenser to
verify that water is flowing throughthe
appliance.
4
Check the connecting tube and joints for
leaks once again.
5
The water filter should be fixed at a
appropriate place where it is easy to reach
for replacement purposes.
To Next Page
Loading...
