LG GT540 - Page 50

- 51 -
Copyright © 2010 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
3. TECHNICAL BRIEF

ͽ͸ͶͺΟΥΖΣΟΒΝΆΤΖ΀ΟΝΪ

3.12.1.4. LBEH19UNBC-338 (BT / WiFi module )
1. WiFi
* WLAN_CMD : WLAN SDIO Command Line.
* WLAN_CLK : WLAN SDIO Clock Input.
* WLAN_SDIO[3:0] : WLAN SDIO Data Line.
* WLAN_RESET_N : Low asserting reset for WLAN core.
* WLAN_HOST_WAKEUP : WL_HOST_WAKEUP signal output.
2. BT
* BT_UART_RXD : Bluetooth UART Serial Input.
* BT_UART_RTS : Bluetooth UART Request to Send. Active-low request.
* BT_UART_CTS : Bluetooth UART Clear to Send. Active-low clear.
* BT_UART_TXD : Bluetooth UART Serial Output.
* BT_PCM_CLK : BT PCM clock, can be PCM-master (output) or PCM-slave (input).
* BT_PCM_DIN : BT PCM data input.
* BT_PCM_SYNC : BT PCM sync signal, can be PCM-master (output) or PCM-slave (input).
* BT_PCM_OUT : BT PCM data output.
* BT_WAKEUP : BT Wakeup Input.
* BT_HOST_WAKEUP : BT Host Wakeup Output
* BT_RESET_N : Low asserting reset for BT core.
3. Common
* WLAN_REG_ON : If low the internal regulators will be disabled.
* SLEEP_CLK : LPO clock (32.768kHz) input. Used for low-power mode timing.
* CLK_IN : Crystal amplifier input or frequency reference input.
* CLK_REQ : Crystal Circuit / Reference Clock Enable (active-high)
4. FM Radio
* FM_ANT : FM RF input.
* SLEEP CLK : External reference oscillator input. (32.768KHz)
* FM_R : Right audio line output – digital input data.
* FM_L : Left audio line output – digital frame synchronization.