LG HT-C186HLA1 - Page 12

Cassette Type Air Conditioner
12
Installation
The Indoor Unit Installation
• The following parts is option.
Hanging Bolt - W 3/8 or M10
Nut - W 3/8 or M10
Spring Washer - M10
Plate Washer - M10
• Drill the piping hole on the wall slightly tilted to the
outdoor
side using a Ø 70 hole-core drill.
Wall
m
m
7~
5
Indoor Outdoor
Set screw of
paper model (4 pieces)
Paper model
for installation
Ceiling board
m
m0
5
1
Adjust the same height
Ceiling board
Ceiling
Flat washer for M10
(accesso
ry)
Keep the length of the bolt
from the b
racket to 40mm
Open the ceiling board
along the outer edge of the
paper model
Flat
washer for M10
(accesso
ry)
Hanging bolt
(W3/8 or M10)
Nut
(W3/8 or M10)
Nut
(W3/8 or M10)
Spring washer
(M10)
Air Conditioner body
CAUTION: Tighten the nut and
bolt
to prevent unit falling.
Remote Controller Installation
• Although the room temperature sensor is in the indoor unit, the remote controller should be installed in
su
ch places away from direct sunlight and high humidity.
Installation
of the remote controller
• Select places that are not splashed with water.
• Select control position after receiving customer approval.
• The room temperature sensor is built in the indoor unit.
• This remote controller equipped with liquid crystal display. If this position is higher or lower, display is difficult to
se
e.(The standard height is 1.2 ~ 1.5m high)
Routing
of the remote controller cord
• Keep the remote controller cord away from the refrigerant piping and the drain piping.
• To protect the remote controller cord from electrical noise, place the cord at least 5cm away from other power
ca
bles (audio equipment, television set, etc.)
• If the remote controller cord is secured to the wall, provide a trap at the top of the cord to prevent water
droplets
from running.