LG HT-C186HLA1 - Page 13

13Installation Manual
Installation
1. Remove the battery cover from the remote controller.
• Slide the cover according to the arrow direction.
2. Insert the two batteries.
• Be sure that the (+) and (-) directions are correct.
• Be sure that both batteries are new.
3. Re-attach the cover.
• Slide it back into position.
• Fix the under plate on the wall
• Separate the under plate from Remote control box.
• Fix the cord clamps on the wall by
ø 3 tapping screws (accessory).
• Fix the remote control cord.
Remote control
box body
Cord clamp
(accesso
ry)
Lever carefully
the b
ox open
using a screw
driver, etc.
Front case
t
r
a
p
r
e
w
o
l
e
h
T
Face of wall
Under plate
Scr
ew (accessory)
WIRED REMOTE CONTROL INSTALLATION
REMOTE CONTROL PREPARATION
DISASSEMBLING
ELECTRICAL WIRING
HOW TO MOUNT ONTO A WALL
HOW TO INSERT BATTERIES
Wire and make sure that teminal
numbers are matched on unit side and
remote controller side.
The maximum length of the cord is 100m.
If the length of the cord
exceeds 50m,
use a wire si
ze greater than 0.5mm
2
.
Remote controller
(Main board)
CN REMO
• Do not use rechargeable
batte
ries, such batteries differ
from
standard dry cells in
shap
e, dimensions, and
per
formance.
• Romove the batteries from the
remote
controller if the air
conditioner
is not going to be
used
for some long time.
HOW TO INSERT BATTERIES