A9
Connecting to a PC
Press the Power button on the front side of the monitor to turn it on.
When the power is on, “Self Image Setting Function” function will start
automatically. (Supported for the analog signal only.)
Close the back door when the connection is complete
Please refer to the following figure to tie up the cables.
Once the cable is connected up as shown in the figure, it will be arranged properly,
which facilitates stand angle adjustment.
Connect the cables as described below !
What is the “
Self Image Setting Function
” function?
This function provides the optimal screen state for the user. When you connect the monitor for
the first time, automatic screen adjustment will begin for each type of signal. If you want to
adjust the screen while it is in use or execute this function manually, press the AUTO button at
the front side of the monitor.
Alternatively, execute the “Preset Mode” menu in the OSD menu. However, note that all other
menus except the language menu will be initialized at the same time if you execute the “Preset
Mode” menu.
To connect to two PCs
Connect the signal cables (DVI and D-Sub) to each computer respectively.
You can select the computer to use using the SOURCE button on the front of the monitor.
Directly connect to the multi tab integrated with a conductor, or an earthed wall power outlet.
You cannot use tablet drive and application software on Macintosh.
3
4
Note
To Next Page
Loading...
