A17
Adjustment on the OSD (On Screen Display) Screen
You need to adjust the screen if you connect the monitor to the new
computer or change the mode.
Refer to the following description to keep the screen in an optimal state.
Press the AUTO/SET button to carry out automatic screen adjustment that best fits into the current screen
mode. If adjustment is found to be unsatisfactory, you may need to adjust screen position, frequency or
brightness manually in the OSD menu. (Supported only for the analog signal only.)
Screen Selection and Adjustment
Selects the
menu icon
Selects the icon
Adjusts the status
Selects the
adjustment
value/Closes the
OSD screen
Press the MENU button to open the OSD screen.
Adjust the OSD menu item using the
> < button.
When the menu icon is selected, press the AUTO/SET button
Adjust the item values using the
> < button. To move down to the sub-menu or other menu, press the
AUTO/SET button to move.
To select other functions or to return to the previous screen, press the MENU button again.
Press the MENU button twice to close the OSD screen.
Automatic Saving Function
When you select another menu or close the OSD screen after changing the value while the OSD screen is
open, the adjusted value will be automatically saved. Even though you don’t close the screen after
adjustment, the OSD will disappear automatically and the adjusted values will be saved accordingly.
1
2
3
4
OSD(On Screen Display)
The OSD screen provides graphical presentation of the screen adjustment state so that you can
change the setting visually.
[Note] The language displayed in the monitor may differ from the one in the User’s Manual.
Pops up the
OSD screen
Adjusts the OSD screen easily and automatically…
Note
To Next Page
Loading...
