HOWTO USE 27
Automatic Icernaker
* Depending on the model, some of the
following functions may not be available.
Ice is made in the automatic icemaker and sent
to the dispenser. The icemaker will produce
12 cubes per cycle--approximately 120 cubes
in a 24-hour period, depending on freezer
compartment temperature, room temperature,
number of door openings and other operating
conditions.
• It takes about 12 to 24 hours for a newly
installed refrigerator to begin making ice. Wait
72 hours for full ice production to occur.
• Ice making stops when the in-door ice bin
is full. When full, the in-door ice bin holds
approximately 6 to 8 (12-16 oz)glasses of ice.
• The water pressure must be between 20 and
120 psi on models without a water filter and
between 40 and 120 psi on models with a
water filter to produce the normal amount and
size of ice cubes.
• Foreign substances or frost on the ice-
detecting sensor can interrupt ice production.
Make sure the sensor area is clean at all times
for proper operation.
Icemaker --
Switch
Ice-defecting
Sensor
Water fills the ice tray.
1 hour later from
supplying water
60 minutes after water has been added
to the ice tray, the ice tray will sit slightly
tilted to help the cold air reach the ice.
The ice-detecting sensors will sense
when the ice is ready to be dumped
into the ice bin.
Turning the Automatic Icekamer
On or Off
To turn off the automatic icemaker, set the
icemaker switch to OFF (O). To turn on the
automatic icemaker, set the switch to ON (J).
To Next Page
Loading...
