- 15 -
3-19-2 Follow Steps to Reinstall
Step 1) Reinstall the right side of the gear into the clip.
Step 2) Insert the rail into the right side of the gear. Gears
do not need to be perpendicular to each other.
Step 3) Insert the rail into the left side of the gear, and
insert the gear into the clip.
Step 4) The rail system will align itself by pushing the rails
all the way into the freezer section.
Pull the rails back out to full extension.
Step 5) Reinstall the freezer door by inserting the rail tabs
into the guide rail.
Step 6) Reinstall 2 screws into the guide rail one on each
side.
Step 7) Reinstall the lower basket, and close the freezer
door.
Figure 53
Figure 55Figure 54
Figure 56 Figure 57
Figure 59Figure 58
To Next Page
Loading...
