- 82 -
0Q%JGEMKPI(NQY 4GUWNV58%#EVKQP
ඖ
%JGEMVJG(TGG\GTFQQTUYKVEJ
The Switch senses if the door is open or close.
.When the door open, lamp On
.When the door Close, lamp Off
ȉ close Door and check the lamp Through the gap
ඖ
Check Voltage between pin 21 and 22
3
ඖ
Check the Reed S/W resistance
-.No Magnet
-.Magnet Near the Switch
CON7
-.Resistance & Service Action
-.Magnet must be center of Switch
Magnet Center
Switch Center
(O)
Good position
Bad position
(X)
Magnet Center
Switch Center
,QFDVHRI
6WDWXV
5HVXOW 69&$FWLRQ
'RRU &ORVH
9Ȥ
&KHFN5HHG6:
&KHFN+DUQHVV
disconnection
,I 1RRNFKDQJH 3&%
,QFDVHRI
'RRU 2SHQ
9
1.CheckReed S/W
2.CheckHarness disconnection
3.If No.1,2 ok ,change PCB
2
2
10-5-2 Door Switch,F