Removing Condensation
Buildup
Condensation can build up inside the unit
when the Cool and Dry modes are used.
The fan can be set to run for a short period
after the product is turned off to help keep
the inside of the appliance dry. This option is
off by default.
Turning Condensation Fan On
1 Turn on the product, set it to Cool mode
and let it run for at least 10 seconds.
2 Press and hold the Mode and Fan Speed
buttons on control panel for 3 seconds
until On appears in the display.
3 The condensation fan is now turned on.
When the appliance is turned off, Co
appears in the display and the fan will
continue to run for 10 minutes. The
appliance will then shut down as normal.
Turning Condensation Fan Off
1 When the product is powered on, press
and hold the Mode and Fan Speed
buttons on control panel for 3 seconds
until OF appears in the display.
2 The condensation fan is now turned off.
The appliance will shut down
immediately when it is turned off.
NOTE
• Some functions cannot be used while this
option is turned on.
9
Auto Swing
This functions may not be supported,
depending on the model.
6
Light
Sets the display screen brightness:
On → Off
7
Clean Filter
The Clean Filter LED lights up to notify
you that the filter needs to be cleaned.
After cleaning the filter, press and hold the
Mode button on the control panel for 3
seconds to turn off the Clean Filter light.
NOTE
• The filter reset must be done using the
control panel, not the remote control.
• This feature is a reminder to clean the air
filter for more efficient operation. The
LED light turns on after 250 hours of
operation.
8
To Next Page
Loading...
