11
EN
PREPARING FOR INSTALLATION
Basic Installation Materials Supplied
Shape Parts Name Shape Parts Name
Hose
Mounting plate
insulation (2 pcs)
Base mounting plate
(23”, 1 pcs)
Window gap
insulation (1 pcs)
Extension mounting
plate (16”, 1 pcs)
Fixing clips
(2 pcs)
Extension mounting
plate (23”, 1 pcs)
Security brackets
(2 pcs)
Mounting plate screws
(4 pcs)
Bracket screws
(2 pcs)
Adhesive short foam
weather seals (2 pcs)
Installation Tools
Shape Parts Name Shape Parts Name
⊕ Driver
Power drill,
Ø 3mm drill blade
Tape ruler, knife
“No residue”
duct tape
* Installation tools are not included with the product.
SELECTION OF INSTALLATION LOCATION
1
Place the unit on a level floor.
2
For best performance, allow at least 8” of
air space on all sides of the unit for good air
circulation.
3
Place the unit near a window. The hose
and diffuser will be used to connect the air
conditioner to the window installation kit to
vent exhaust air outside.
NOTE
• After installation, the Hose length is
approximately 35.5” or less for best
performance.
To Next Page
Loading...
