- 21 -
8. Forced Operation
Operation procedures when the remote control can't be
used.
Open the front panel upward and move the Slide Switch
to the Forced Operation position.
If you want to stop operation, move the Slide Switch to
the Auto Restart or the Remote Control position.
In case the power comes on again after power failure on
the Forced Operation position, the operating conditions
are automatically set as follows:
During Forced Operation, the initial mode continues.
9. AUTO RESTART
In case the power comes on again after a power failure,
Auto Restarting Operation is the function to operate pro-
cedures automatically to the previous operating condi-
tions.
If you want to use this operation, Open the front panel
upward and move the slide switch to the Auto Restart
position.
If you do not want to use this operation, move the Slide
Switch to the Remote Control position.
When you are out for a while, put the Slide Switch
on the Remote Control.
Cooling Heat pump Model
Model
Room Temp. ≥ 24°C(76°F)
21°C(70°F) ≤ Room Temp. < 24°C(76°F)
Room Temp. < 21°C(70°F)
Operating mode Cooling Cooling Healthy Dehumidification Heating
Indoor FAN Speed
High High
Healthy Dehumidification Rule
High
Setting Temperature
22°C(72°F) 22°C(72°F) 23°C(74°F) 24°C(76°F)
To Next Page
Loading...
