Additional features
.o
.o
t_
"0
0
B Sleep Mode
_1_ Press the Sleep Mode Auto button to set the
time you want the unit to turn off automatically.
O The Timer is programmed in one-hour
increments by pressing the Sleep Mode Auto
button 1 to 7 times.
The sleep mode is available for 1to 7 times, To
alter the time period in steps of 1 hour, press
the Sleep Mode Button while aiming at air
conditioner.
O Make sure the Sleep ModeAuto LED lights up.
Setting the Time
,_, To cancel the Sleep Mode, press the sleep
Mode Auto button several times until the star
(_) disappears from the operation display.
Note: The Sleep Mode will be operated at
low fan speed (cooling) or medium fan
speed (heat pump only) for quiet sleeping.
IN COOLING MODE: The temperature will
automatically rise by 1°C over the next 30
minutes and by 2°C in 1 hour for comfortable
sleeping.
O Timecan be set only whenyou have pressed
the Reset button. Ifyou have just replaced the
batteries, the Reset button should be pressed
to reset the time.
O Pr:s_rStdhleTier_esSet.ttingbutt° ns until the
Pressthe Start/Stop button.
O
Press the Timer SET button, s_
Note: Check the indicator t _
for A.M. and P.M.
I Delay Start/Pre-Set Stop
OMake sure the time is setcorrectlyon the
remote control display.
O Press the ON/OFF Timer
buttons to turn Timer on or off.
O Press the Time Setting [_1__ _.(_E_ _
buttons until the desired
time is set.
O Press theselectedon/offsetting by (_
pressingthe Timer SET button while
aiming the remote control at the signal
receptor.
To cancel the setting the timer.
Pressthe Timer Cancel button while
C_EL
(_ aiming remote control at the signal
receptor.
(The timer lamp on the air conditioner and
the display will go out.)
NOTE: Select one of the following four types of operation.
with the unit runnino
Delay OFF Timer DelayON Timer Delay OFFand ON Timer E)elayONand OFF Timer
@
To Next Page
Loading...
