LG LS-L1210HL - Auto Operation; Activating Auto Operation

p-
.o
.>,
Auto Operation
]
Press the Starl/Stop button.
The unit will respond with
a beep.
2
Open the door on'the remote control. To select Auto
Operation, press the Operation Mode Selection button.
Each time the button is pressed, the operation mode is
shifted in the direction of the arrow.
Cooling Auto Heallhy Heating
Dehumidifica_onCleatpropmodetody)
3
The temperature and fan speed are automatically set by the
electronic controls based on the actual room temperature. If
you want to change the set temperature, close the door on
the remote control and press the Room Temperature Setting
buttons. The cooler or warmeryou feel, the more times (up to
two times) you should press the button. The set temperature
will then be changed automatically.
Sethe temperature
er thetemperature
[
"_ During Auto Operation:
rJ You cannot switch the indoorfan speed. Ithas already been set by the Fuzzy rule.
"_ !.JIf the system is not operating as desired, manually switch to another mode. The system will not
automatically switch from the cooling mode to the heating mode, or from heating to cooling, it must be
done by manually resetting.
"_ LI During Auto Operation, pressing the chaos swing button makes the horizontal louvers swing up and
I_ downautomatically. If youwant to stop auto-swing,press the chaos swing button again.
8;