3. HOW TO INSTALL REFRIGERATOR
- 6 -
1. DOOR ALIGNMENT
Before adjust the doors, remove the Base Grille.
If the freezer compartment door is lower than
the refrigerator compartment door, make them
level by inserting flat blade screwdriver into the
groove of the left leveling leg and rotating it
clockwise.
Left leveling
leg
Height
If the freezer compartment door is higher than the
refrigerator compartment door, make them level by
inserting flat blade screwdriver into the groove of
the right leveling leg and rotating it clockwise.
Left leveling leg
Height
difference
Adjust the level when the refrigerator door is lower than
the freezer door during the installation of the refrigerator.
Tools you need
• Wrench 5/16 in (8 mm)
• Wrench 3/4 in (19 mm)
AFTER LEVELING THE DOOR HEIGHT
Make sure the front leveling legs are completely
touching the floor.
difference
Height
difference
Height
difference
Height
difference
Height
difference
Using a ¾” (19 mm) wrench, turn the keeper nut clockwise
to lossen the keeper nut.
Keeper nut
Adjustment
hinge pin
Wrench
Up
Down
Using a 5/16” (8 mm) wrench, turn the adjustment hinge pin
clockwise or counterclockwise to level the refrigerator and
After setting the level door, turn the keeper nut
counterclockwise to tighten.
Do not over tightening the door adjustment screw. The
hinge pin can be pulled out. (Adjustable range of height is a
maximum of ½” (1.27 cm)).
freezer door.
To Next Page
Loading...
