Ceiling & Floor, Ceiling Suspended (50Hz, R22) 87
16. Function of Remote Controller
Signal transmitter
Transmits the signals
to the room air conditioner.
1 OPERATION DISPLAY
Displays the operation conditions.
2 START/STOP BUTTON
Operation starts when this button is pressed and stops
when the button is pressed again.
3 OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
4 ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation.
5 TIME SETTING BUTTONS
Used to adjust the time.
6 TIMER SET/CANCEL BUTTONS
Used to set the timer when the desired time is obtained
and to cancel the Timer operation.
7 AIR FLOW DIRECTION START/STOP BUTTON
Used to stop or start louver movement and set the desired
up/down airflow direction.
8 SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation.
9 AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating
(turns indoor fan on/off).
10 ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
11 RESET BUTTON
Used prior to resetting time or after replacing batteries.
Cooling Only Model(18k, 24k, 28k)
To Next Page
Loading...
