LG M4210D-B21 - Page 48

Controlling the Multiple Product
RS-232C
14
25. PC Power On/Off (Command : d s)
To turn On and Off the built in PC.
Transmission
[d][s][][Set ID][][Data][x]
Data 0 : PC Power Off
1 : PC Power On
Acknowledgement
[s][][Set ID][][OK/NG][Data][x]
*This operates only when ‘PC Control’ is ‘Off’.
▲
26. PC Control On/Off (Command : d t)
It sets the synchronized power on/off between the built-in PC of the monitor and the monitor.
Transmission
[d][t][][Set ID][][Data][x]
Data 0 : Off
1 : On
Acknowledgement
[t][][Set ID][][OK/NG][Data][x]
▲
Transmission / Receiving Protocol
27. Input Selection (Command : b) (Main Picture Input)
To select input source for the Set.
You can also select an input source using the INPUT
button on the remote control.
Transmission
[x][b][ ][Set ID][ ][Data][Cr]
Data 01 : RGB
06 : RGB
08 : DVI
Acknowledgement
[b][ ][Set ID][ ][OK][Data][x]
▲