Installation of filters
Premium type
1 Pull out the 3M Filter from the separately
packed plastic bag.
2 Detach the two nitto tapes from the filter.
3 Insert the filter into the filter case.
4 Detach two nitto tapes from the plasma fil-
ter.
Rational type
1 Pull out the 3M Filter from the separately
packed plastic bag.
2 Insert the 3M Filter into the left or right
case.
3 Detach two nitto tapes from the plasma fil-
ter.
* The feature can be changed according to
type of model.
Test Running
- Check that all tubing and wiring are properly
connected.
- Check that the gas and liquid side service
valves are fully open.
Prepare remote controller
1 Remove the battery cover by pulling it ac-
cording to the arrow direction.
2 Insert new batteries making sure that the
(+) and (–) of battery are installed correctly.
3 Reattach the cover by pushing it back into
position.
NOTE
!
• Use 2 AAA(1.5volt) batteries. Do not use
rechargeable batteries.
• Remove the batteries from the remote
controller if the system is not used for a
long time
16
INSTALLATION
ENGLISH
To Next Page
Loading...
