LG PREMTA200 - Estimated Energy Display; CN-PTC; Temperature Compensation; Humidity Compensation

27INSTALLER SETTING
Function
Product
Description Option
AIRCON VENTILATOR
Estimated Energy
Display
O
This function can set to display energy data which
outdoor unit estimated.
On / Off
CN-PTC O
This is a function to select the use of CN-Port of
indoor unit.
On / Off
Temperature
Compensation
O
You can display on the screen by applying offset
to the temperature value detected by the remote
controller.
Humidity
Compensation
O
Offset can be applied to the humidity value
detected by the remote controller to display on the
screen.
FAN Operation Time O
This function displays the accumulated operating
time of the indoor Fan motor.
Function
Product
Description Option
AIRCON VENTILATOR
Indoor Temperature
Master/Slave
O
This function sets the master/slave for the
temperature sensor by indoor unit.
Master/ Slave Master Address
Not use
Master
Slave
00~FF
indoor unit operation
time
O
This function displays the cumulative time of power
applied to the indoor unit.
Indoor unit Physical
address
O Set the physical address of the indoor unit
Thermopile sensor O Set whether to use the floor thermopile sensor. On/off
Air supply ESP O
It is the function to set the air supply fan speed
value
Fan Speed RPM
Low
High
Turbo
0 ~ 255
Air Discharge ESP O
It is the function to set the exhaust fan speed
value.
Fan Speed RPM
Low
High
Turbo
0 ~ 255
Product Direction O
It is the function to set the unit’s installation
direction.
Normal / Reverse
Express Ventilation
setting
O
It is the function to set the priority of the air flow
during the express ventilation operation.
Air Supply First / Air Exhaust First
Humidification of
Stand-Alone Vent.
Mode
O
Set whether to use the humidification function
when operating the ventilation alone.
On/Off
Humidification of
Vent. With Heating
Operation
O
This function sets the heat humidification function
of DX ventilation to automatic or manual.
Automatic / Manual
Vent. Standard Fan
Speed
O
This function changes the standard fan speed of
ventilation.
Basic setting Value / 10% /10% up / 20% down
Filter Check Alarm O
This function sets the filter replacement cycle for
ventilation products.
Step 0 ~ Step 5