110 Outdoor Unit
Test Run
■ Setting the E.S.P (External static pressure)
• Set the connector like the following table when external static pressure is applied on the outdoor unit.
If you set the connector, the RPM of outdoor unit's fans will be changed properly.
• Connector
(In the bag with installation manual)
• Housing (in the Main PCB)
6) External Static Pressure
12 ~ 14 mmAq
Insert connector on following table
Connector
Connector
Connector
Connector Connector
ConnectorConnector
1) External Static Pressure
0 ~ 3 mmAq
2) External Static Pressure
3 ~ 6 mmAq
3) External Static Pressure
6 ~ 8 mmAq
4) External Static Pressure
8 ~ 10 mmAq
5) External Static Pressure
10 ~ 12 mmAq
CAUTION
- The product may not properly operate if the connector is not properly setup.
To Next Page
Loading...
