Caring for Your Dryer
18
C
aring for Your Dryer
1. Take
connecting
kit out.
Ventilation Grille and Cool Air
Inlet Grille
Vacuum the front ventilation grille 3-4 times a
year to make sure there is no build up of lint or
dirt that could cause improper air flow
Moisture Sensor?
The device senses the moisture level of the
laundry during operation, which means it must
be cleaned regularly to remove any build up
of lime scale on the surface of the sensor.
Wipe the sensors inside drum (as illustrated)
2. Separate
water
container
hose from
the kit.
3. Connect
drain hose
to the kit.
Condensed Water Drain-out
Normally, condensed water is pumped up to the
water container where water is collected until
manually emptied. Water can also be drained
out directly to a mains drain, especially when the
dryer is stacked on top of a washing machine.
With a connecting kit for a mains drain hose,
simply change the water path and reroute to the
drainage facility as below:
Note
- Warm air is exhausted through the venti-
lation grill
- Adequate ventilation has to be provided
to avoid the back flow of gases into the
room from appliance’s burning other
fuels, including open fires.
To Next Page
Loading...
Need help?
General
