13
O
perating your dryer
Before first use of the dryer
Turn on.
Open the
Door.
Clean the
lint filter.
Before you use the dryer for the first time, there are some points that you have to check.
After removing package, you will check the product has no problem and is properly installed.
1. Check the dryer is well balanced by using a leveller. In order to check this, you can see and adjust legs which are supposed to stay put.
2. Check some major parts such as door control panel and drum.
3. It is needed to operate 5 minutes drying to make sure drum inside gets warm.
4. In the early use of dryer, please leave it with door opened and power unplugged after operation to get rid of probable smell inside.
1.
Turn power on.
First, press the “Power” button. The indicator
light above the button will become illuminated
indicating that the machine is all set to run.
4.
Place laundry into the drum
after sorting.
The clothes should be sorted by its fabric
type and dryness level and all the strings
and belts of clothes should be well tied and
fixed before being put into the drum.
It is desired that you push laundry all the
way back to keep it away from the door
seal. If not, door seal and clothes may be
damaged.
3.
Check the lint filter.
The lint filter near the door, should be
emptied after or before drying operation.
Open the door and check if lint filter is
cleaned. If not, please clean it.
2.
Open the door.
Note
Be careful not to put buttons, small laundry and any
kind of small stuffs into the holes below the door
Operating your dryer
To Next Page
Loading...
