THERMA V Split Type
10. Accessories
30
Hydro Box Unit
10.2.2 Installation Method
How to use
1. After deciding where the remote temperature sensor is installed, decide the location and height of the fixing
screws. (Interval between the screws : 60mm)
2. Insert the connector of the connection wire into the space for the connector in place of the room temperature
sensor. (CN_ROOM)
3. Separately, set the option code of the attached controller on the indoor unit. In detail, refer to "installer setting
mode" in the owner's manual.
How to connect the remote temperature sensor and the connection wire
The Connection wire does not matter if you change the color of the wire because of non-polar
How to install the remote temperature on the wall
Integrate the remote temperature sensor with the screws as the order of arrows.
CAUTION
1. Choose the place where the average temperature can be measured for the place the indoor unit operates.
2. Avoid direct sunlight.
3. Choose the place where the cooling/heating devices do not affect the remote sensor.
4. Choose the place where the outlet of the cooling fan do not affect the remote sensor.
5. Choose the place where the remote sensor isnʼt affected when door is open.
Fixing screws
60mm
Fixing the
Remote Sensor
To Next Page
Loading...
