When only WASH • RINSE • SPIN
Press the POWER
button.
Load the laundry and close the door.
Add detergent and then close the dispenser
drawer.
Refer to page 10 for the amount of detergent.
1
Select the wash types desired
by pressing the WASH button.
After the TURBO SHOT
Press the RINSE button to select NO RINSE.
Press the SPIN button to select NO SPIN.
2
Press the START/
PAUSE button.
Then, it locks the door, supplies water, and starts
washing.
3
To WASH only
Press the POWER
button.
Load the laundry and close the door.
Add fabric softener and close the drawer.
Do not add any detergent.
1
Press the RINSE button and
select the number of rinse
desired.
2
Press the START/
PAUSE button.
Then, it locks the door, supplies water, and starts
washing.
It will drain the water at the last rinse cycle.
3
To RINSE only
Press the POWER
button.
Load the laundry and close the door.
Do not add any detergent or fabric softener.
1
Press the SPIN button and
select the SPIN speed.
2
Press the START/
PAUSE button.
Then, it locks the door and starts spinning or
draining.
3
To SPIN only
Please note!
This displays the selected ones at the bottom of the LED panel.
When the WASH or RINSE cycle is selected and the cycles finish, it automatically drains the water to prevent the decrease of the washer reli-
ability due to the deformation of the door gasket by the rinsed water in the drum for a long time.
When the TURBO SHOT function is selected, you cannot select NO RINSE or NO SPIN.
To Next Page
Loading...
