CHILD LOCK function
To change the course or cycle when the CHILD LOCK is already set
When the POWER is on while the CHILD LOCK has already been set
Use of this function is to prevent accidents that are caused by children’s use of the machine.
Press the ‘WASH’ and ‘RINSE’ buttons simulta-
neously for 3 seconds to enable and disable the
CHILD LOCK function.
Once the CHILD LOCK function is set, all other
buttons are disabled except the POWER button.
The power button is enabled for the user’s
safety.
To set the CHILD
LOCK function
Select
the
course
desired.
Disable the
CHILD LOCK
by pressing
the WASH and
RINSE buttons
simultaneously
for 3 seconds.
1
Press the
START/
PAUSE
button to
stop the
operation.
2
Select a course
or function
to change,
and press the
START/PAUSE
button for
operation.
3
You may set or clear during the operation
Once the CHILD LOCK function is set, all other buttons except the POWER button are inactivated.
Even after the end of every cycle, the CHILD LOCK is not automatically unlocked. To unlock, the WASH and RINSE buttons have to be
pressed and held for 3 seconds.
If the POWER is on while the
CHILD LOCK has already been
set, [ ] is ON.
1
Press the ‘WASH’ and ‘RINSE’ buttons
simultaneously for 3 seconds, and
disable the CHILD LOCK.
2
Dial the Course Selector Knob
for the desired course.
You may change the water temperature, number
of rinse cycles and spin speed by pressing the
buttons accordingly.
3
Use
To Next Page
Loading...
