29
ENGLISH
1 Power (Command: k a)
► To control power On/Off of the set.
Transmission
(k)(a)( )([Set ID])( )([Data])(Cr)
[Data] 00: [Off]
[Data] 01: [On]
Ack
(a)( )([Set ID])( )(OK/NG)([Data])(x)
► To show TV is power on or off
Transmission
(k)(a)( )([Set ID])( )(FF)(Cr)
Ack
(a)( )([Set ID])( )(OK/NG)([Data])(x)
* Similarly, if other functions transmit ‘0 x FF’ data
based on this format, Acknowledgement data feed
back presents status about each function.
* OK Ack., Error Ack. and other message may display
on the screen when TV is power on.
2 [Aspect Ratio] (Command: k c) (Main Picture Size)
► To adjust the screen format. (Main picture format)
You can also adjust the screen format using the
picture settings.
Transmission
(k)(c)( )([Set ID])( )([Data])(Cr)
[Data] 01: [4:3] (Normal screen - [Just Scan] Off )
[Data] 02: [16:9] (Wide screen - [Just Scan] Off )
[Data] 06: [Original] ([Just Scan] Off )
[Data] 09: [Just Scan]
* Please make sure that the model doesn’t support
both Vertical Zoom and All-Direction Zoom mode.
Ack
(c)( )([Set ID])( )(OK/NG)([Data])(x)
* Using the PC input, you select either [16:9] or [4:3]
screen aspect ratio.
* In DTV/HDMI (1080i 50 Hz / 60 Hz, 720p 50 Hz / 60
Hz, 1080p 24 Hz /30 Hz / 50 Hz / 60 Hz), Component
(720p, 1080i, 1080p) mode, [Just Scan] is available.
* Full Wide is supported only for Digital, Analogue,
AV.
3 Screen Mute (Command: k d)
► To select screen mute on/off.
Transmission
(k)(d)( )([Set ID])( )([Data])(Cr)
[Data] 00: Screen mute off (Picture on) / Video mute
off
[Data] 01: Screen mute on (Picture off)
[Data] 10: Video mute on
Ack
(d)( )([Set ID])( )(OK/NG)([Data])(x)
* In case of video mute on only, TV will display On
Screen Display(OSD). But, in case of Screen mute on,
TV will not display OSD.
4 Volume Mute (Command: k e)
► To control volume mute on/off. You can also adjust
mute using the mute button on remote control.
Transmission
(k)(e)( )([Set ID])( )([Data])(Cr)
[Data] 00: Volume mute on (Volume off )
[Data] 01: Volume mute off (Volume on)
Ack
(e)( )([Set ID])( )(OK/NG)([Data])(x)
5 Volume Control (Command: k f)
► To adjust volume. You can also adjust volume with
the volume buttons on remote control.
Transmission
(k)(f)( )([Set ID])( )([Data])(Cr)
[Data] Min: 00 to Max: 64
* Refer to “Real data mapping”.
Ack
(f)( )([Set ID])( )(OK/NG)([Data])(x)
To Next Page
Loading...
