1.5 m 1.5 m
2 m
Please, turn the
power switch ON.
Operation mode and cleaning
Installation of Home Station
Power ON and cleaning
1. Operation mode 2. Starting location
1. Install the Home Station after removing the
protection plastic wrap.
2. While in use (cleaning/recharging), always
keep the power cord plugged.
1. Turn the Main Power Switch on the rear-left
of main unit.
3. Starting and stopping the cleaning
2. Turn the power ON by pressing the 'Start/
Stop' button on main unit.
Be careful not to touch the main button on the unit, when
switching ON the power. Otherwise, the button may
possibly not work.
Pressing the button may turn ON the display.
Make sure to install it on a plane spot free of obstacles
within a 1.5 m distance left-right and 2 m distance
forward and not exposed to direct sunlight.
Keep the spare cords in order on the power cord hook.
• If the Charging Terminal has dusts on it, recharging could
fail. Clean regularly the Terminal with a dry mop.
• When putting the Robot Cleaner upside down, make sure to
put it on a soft cloth laid on the floor.
• Before turning over the main unit, remove the Dust Bin, first.
Otherwise, dusts may pour down from the Bin.
Tip
▒
A correct starting point
▒
A wrong starting point
Power cord not connected
to Home Station
Start near the wall Start with a hand blinding
the sensor lens
www.lg.com
Quick Guide
This guide briefly describes how to use the Cleaning Robot.
For more detail, please refer to the user manual
Please read carefully this before installing and operating the product.
Cleaning Robot
VR6260 Ser.
VR6270 Ser.
[Main Power Switch
protection cap]
Chair
Corner
Carpet
Next to a Couch
Check if the LED glows red
in recharging.
Power cord connected
to Home Station
No obstacles within
a 30 cm radius
With the Robot Cleaner's power ON, pressing the 'Start/
Stop' button will start the cleaning, and another pressing
will stop it.
▒
ZigZag
: Swiftly clean a wide
space
▒
Cell by Cell
: Meticulously clean a
complex environment
▒
My Space
: Clean a desired,
particular spot
▒
Spot Cleaning
: Intensely clean an area
of a 1.5 m diameter
1.5
m
Mi espacio
After the Robot Cleaner is turned on, press the 'Start'
button on the remote control. A melody will sound and
cleaning will begin.
Press the STOP button during the cleaning cycle to
'Stop' cleaning.
To Next Page
Need help?
General
