—9—
1.5.2 COOLING ONLY MODEL WITH REMOTE CONTROL AND TOUCH TYPE
POWER BUTTON
To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
This button takes priority over any other buttons.
OPERATION MODE SELECTION BUTTON
Every time you push this button, it will toggle COOL, FAN and DRY.
ON/OFF TIMER BUTTON
Everytime you push this betton, timer is set as follows.(1Hours ➔2Hours➔ 3Hours➔ 4Hours➔ 5Hours➔ 6Hours➔
7Hours➔ 8Hours➔ 9Hours➔ 10Hours➔ 11Hours➔ 12Hours➔ Cancel)
FAN SPEED SELECTOR
Everytime you push this button, it is set as follows.
( High [F3] ➔ Low[F1] ➔ Med[F2]➔ High[F3]... )
ROOM TEMPERATURE SETTING BUTTON
This button can automatically control the temperature of the room.
The temperature can be set within a range of 16˚C to 30˚C by 1˚C or within a range of 60°F to 86°F by 1°F.
Select the lower number for lower temperature of the room.
ENERGY SAVER
The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will tern on and check the room air to determine if cooling is needed.
AUTO SWING
This button can automatically control the air flow direction.
SLEEP MODE BUTTON
Press the sleep mode button to set the time you want the unit to turn off automatically. The timer is programmed in one
hour increment by pressing the button. Every time you push this button, the remaining time will be set as follows.(1Hour ➔
2Hours ➔ 3Hours ➔ 4Hours ➔ 5Hours ➔ 6Hours ➔ 7Hours ➔ 0Hour ➔ 1Hour➔ 2Hours➔... )
Note: The Sleep Mode will be operated at low fan speed for quiet sleeping. The temperature will automatically rise by 1°C
over the next 30 minutes and by 2°C in 1 hour for comfortble sleeping.
REMOCON SIGNAL RECEIVER
To Next Page
Loading...
