9
nstallation
I
Normal Tap without thread & screw type inlet hose
1. Unscrew the fixing screw to
attach the tap.
2. Push the connector up till the
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
3. Push the water supply hose
vertically upwards so that the
rubber packing within in the
hose can adhere completely to
the tap and then tighten it by
screwing it to the right.
Rubber
packing
Rubber packing
Upper
Connector
Upper
Connector
Plate
Water supply hose
Upper Connector
Fixing screw
Normal Tap without thread & one touch type inlet hose
1. Untighten the upper connector
screw.
2. Push the upper connector up till
the rubber packing is in tight
contact with the tap. Then tighten
the 4 screws.
3. Connect the water supply hose to
the middle connector, pushing
the plate down.
• Your machine comes with only
cold water connection.
• Make sure that there are no
kinks in the hose and that it is
not crushed.
• In case the diameter of the tap
is large remove the guide plate.
• Turn the middle connector not
to have water leaked.
• Make sure that the rubber seal
is inside the hose connector.
• To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
Rubber
packing
Rubber packing
Middle
connector
Middle
connector
Hose connector
Rubber seal
Upper
Connector
Connector
Upper Connector
Upper
Connector
Plate
Guide Plate
Water supply
hose
Fixing screw
Horizontal tap
Extension tap
Square tap
Used the horizontal tap
To Next Page
Loading...
