SPIN TROUBLE
Check the sensor
(Pressure) or hose
(Sensor).
If the problem is on the
sensor or the hose, replace
the sensor or the hose.
Normal
Correct the connector.
Replace the motor
assembly.
(Refer to the replacement
parts list)
Check on the spinning, is the frequency of the
water level 248 or more. The frequency can be
checked by pressing the Bio and Time Delay buttons
at the same time on the program.
When pressing Pre Wash, Crease Care, and
POWER buttons at the same time after power off,
press the START/PAUSE button 2 times, is the drum
low speed spin?
Is it disconnected, or disassembled?
Red:3pin ( )
Check the motor connector. Is the resistance of
the terminal same as the figure?
MOTOR TERMINAL
Resistance of terminal:
About 6.5
Replace the PWB assembly (Main)
To Next Page
Loading...
