• Electrical connection
1. Donot usean extensioncord or doubleadapter.
2. If the supplycord isdamaged,it must be replacedbythe manufactureror its service agents
or similarlyqualifiedperson in orderto avoid a hazard.
3. Alwaysunplugthe machineand turnoffthe watersupplyafter use.
4. Connectthemachinetoan earthed socketin accordancewith currentwiring regulations.
5. Theappliancemustbe positionedsothat the plug iseasilyaccessible.
• Washing Machine is to be connected to the water mains using new hoses
Old hoses should not be used.
• Connecting water supply hose
I_ Water supply pressure must be between
4.5 ~ 145 PS1 (30~1000 kPa)
I_Don't strip or crossthread when connecting
Inlet hose to the valve.
I_l]the water supply pressure is more than
I000 kPa, a pressure reducer device should
be installed.
•Two Sealingwasherare suppliedwith the
water inlet hosesto preventwater leaks.
• Checkwatertightnessof washing
machineconnectionsby turningthetap
completelyon.
• Periodicallycheckthe conditionof the
hoseandreplacethe hose if necessary,
• Makesurethatthere isno kinkin the
hoseandthat itis notcrushed.
Hot wateL_
Cold
water
•The Inlethosewhich hasred connectoris
for thehotwatertap.
To Next Page
Loading...
