20
ow to use washer
H
• If the machine encounters a fault during
operation, the associated fault will be
displayed.
“ ” : Water pressure sensing error
“ ” : Problem of overfilling water
“ ” : Door is not closed
“ ” : Water inlet trouble
“ ” : Drainage trouble
“ ” : Unbalanced load
“ ” : Water temperature trouble
“ ” : Over load in motor
“ ” : Over load in motor
“ ” : Water leaks.
※ [WD(M)-16330(5)FD/14330(5)FD/12330(5)FD]
If these error letters are displayed, please
refer to the troubleshooting page26 and
follow the guide.
Display
• When child lock is selected, the
“ ” is displayed.
• When time delay is selected, it shows
the remaining time to finish the selected
program.
• When washing cycle is completed,
“ ” is displayed on the “Multi
display”.
• During washing cycle, the remaining
washing time is displayed.
• Recommended program by manufacturer.
※ ( ) :
WD(M)-14330(5)FD / WD(M)-14331(6)FD
<>:
WD(M)-12330(5)FD / WD(M)-12331(6)FD
- Cotton (95˚C) : around 2 hours and 3 minutes
(around 1 hour and 57 minutes)
<around 1 hour and 57 minutes>
-
Cotton (60˚C) : around 1 hour and 46(40)<40> minutes
- Synthetic : around 1 hour and 20 minutes
- Delicate : around 52 minutes
- Wool/Silk : around 50 minutes
- Hand Wash : around 44 minutes
- Quick 30 : around 30 minutes
- Rinse+Spin : around 24 (21) <18> minutes
- Drain : around 1 minute
• The washing time may vary by the amount of
laundry, water pressure, water temperature
and other washing conditions.
• If an unbalanced load is detected or if the suds
removing program operates, the wash time
may be extended.
(Max. increasing time is 45 minutes.)
1. Special function display
3. Completion of washing
4. Time left
2. Self diagnosis display