36
DOOR HINGE ASSEMBLY
SWITCH ASSEMBLY, DOOR LOCK
WHEN FOREIGN MATERIAL IS STUCK BETWEEN DRUM AND TUB
Take apart the cabinet cover clamp and release the
gasket.
Unscrew 2 screws holding the door lock.
Disconnect the door lock from the wiring connector.
Take apart the cabinet cover clamp and release the
gasket.
Unscrew 2 screws holding the door lock.
Disconnect the door lock from the wiring connector.
Disassemble the door from the door hinge.
Take apart the cabinet cover clamp and release the
gasket.
Unscrew 2 screws on the door hinge.
Push the door hinge arm to the inside of the cabinet
cover for disassembling.
Remove the heater.
Remove the foreign material (wire, coin and others)
by inserting a long bar through the hole.
To Next Page
Loading...
