LG WD1411SBW - Spin; Medic Rinse; Add Item

27
ENGLISH
Spin
•
The Spin speed can be selected by pressing the
Spin
button repeatedly. Higher spin speeds may not be
available on some cycles.
•
Spin Only
1
Press the
Power
button.
2
Press the
Spin
button to select desired RPM.
3
Press the
Start/Pause
button.
NOTE
•
When you select ‘No Spin’, it will still rotate slowly for
a short time to drain quickly.
Medic Rinse
For best results or for cleaner rinsing. This allows the
nal rinse to be heated to 40 degrees.
1
Press the
Power
button.
2
Select a washing programme.
3
Press the
Medic Rinse
button.
4
Press the
Start/Pause
button. Refer to page 23
for programmes that will allow a Medic Rinse
option.
Add Item
Laundry can be added or removed after the washing
programme is started.
1
Press the
Add Item
button when the LED is
turned on.
2
Open the door after door lock is released.
3
Add or remove laundry.
4
Press the
Start/Pause
button again to continue
the cycle. The cycle continues automatically.
NOTE
•
For safety reasons, the door remains locked when the
water level or temperature is high. It is not possible to
add laundry during this time.
•
If the water temperature in the drum is high, wait until
it cools down.
CAUTION
•
When adding laundry, make sure to completely push
it into the drum. If laundry gets stuck in the door latch
hole, the rubber packing may be damaged, causing
water leakage and malfunction.
•
Forcing the door open may cause part damage,
destruction, or safety problems.
•
When opening the door during a wash, caution should
be taken to avoid scalding or water overowing onto
the oor.