36
3) Controlling the harness housing
and PE bag
① Remove Two Keeping Wire at upper and lower
site.
② Take in the PE bag to U-trap's lower.
• Reason for being U-trap:
If water fall at upper part, water is going in PE
bag. U-trap is block water. Therefore using
insulation tape, furl at U-trap part.
③ Service is over, Checking Housing is good or
not.
④ PE bag makes original status. After that, At
Housing bottom 5cm, tie Keeping wire little
loose because need to make space at Housing
bottom.
• Reason for loosely binding Keeping wire: It tie
strong Housing bottom, Get wet there is a risk
in PE bag. Therefore tie little loose, make aire
ow is good.
⑤ Using upper site Keeping wire, tie with cabinet.
To Next Page
Loading...
