17
1.
Fit the machine end of the drain hose to the outlet of
the drain pump and tighten the clamp.
2.
Put the other end of the drain hose over the
standpipe or wash tub.
3.
Fit the plastic holder into either holes for the holder
at the rear of the machine. The holder is possible to
fit at either direction according to location of the
standpipe. Make sure that the holder keeps firmly
the drain hose so that the drain hose should not fall
down as shown in the fig.
(WF-T851, T853, T802, T852)
❏ NOTE
:
●
To prevent syphoning, the drain hose should not
extend more than 50 mm from the end of the
hose guide.
●
The discharge height should be approximately
0.9~1.2m from the floor.
●
You machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL FLOW of any
water that may leak out should the machine malfunction.
It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with a
drain hole (or slope) that will prevent any possibility of water damage to floor coverings or property.
● Check that sealing washers are firmly seated.
● Attach the curved end of the hose to the inlet valve of the washing machine; Tighten the
coupling nuts securely by hand. (Fig. 1)
● Attach the stsraight end of the hose to the tap.
Tighten the coupling nuts securely by hand. (Fig. 2)
● Either hose can be attached to hot inlet valve and tap.
● Turn on the taps and check for leaks. Tighten the coupling nuts firmly if there is any
leakage. If water pressure is strong, close the water tap completely then open it slightly.
● Do not install the washer where it is directly exposed to sunlight, wind, rain etc.
● Plug the power cord of this washer into a properly installed standard power point that is switched & earthed.
● Your machine requires a floor drainage slope(or hole) that will SAFELY DISPOSE of the FULL FLOW of any water that may leak
out should the machine malfunction. It is therefore the OWER’S RESPONSIBILITY to make sure this machine is installed in an
area with a drain hole (or slope) that will prevent any possibility of water damage to floor coverings or property.
● Permissible water temperature : Max 70ºC (160ºF)
● Permissible water pressure : Max 116psi (800kpa, 8kg/cm2), Min 4psi (30kpa, 0.3kg/cm2)
● If water temperature & pressure is greater than above, it may cause damage to the machine. If you have uncontrolled water
temperature & pressure you should fit a temperature &pressure relief valve to ensure that water temperature & pressure relief
valve to ensure that water temperature & water pressure remains within the safe limits. Consult a plumber or electrician if you are
unable to adjust water temperature and pressure.
● Do not over tighten the coupling nuts with a tobl. Inlets are plastic : Do not strip or corssthread.
C. How to install the drain hose
D. Flooding drainage
E. Connect inlet hose
To Next Page
Loading...
