LG WF-T857 - Page 19

19
Close the lid Finish Caution & Note
• The pulsator rotates for 8
seconds to detect the laundry
load.
• Then the WATER LEVEL and
the amount of Detergent to be
used will be shown and water
will be supplied.
• Water will be supplied
for 2 minutes after the
start of the wash to
supplement the water the
laundry has absorbed.
• When the wash
program ends, the
buzzer will ring for
10 seconds before
the Power goes off
automatically.
• If water is already in the tub, or putting wet
laundry into the tub before starting will
increase the WATER LEVEL.
• With lightweight bulky loads, WATER LEVEL
can be set low.
• Changes to Water Temperature (HOT/COLD)
and wash level are possible during
operation.
3
5
6
7
7
7
6
6
6
4
4
4
When setting the WATER LEVEL manually, do not set
to Medium to prevent damage to laundry.
Washing with HOT water may damage the laundry
(Water is set to cold automatically). Ensure that the
load is under 2kg.
In order to avoid damage to laundry,
the spin cycle may appear slow.
This also avoids wrinkles and clothing may still
contain some water. This is normal.
Before starting to wash, make sure that the
laundry is washable.
Washing with HOT water may damage the
laundry (Water is set to COLD
automatically).
Ensure that the load is under 2kg.
7
6
4
7
6
4