TRAINING MANUAL WM0742HGA
WM0742HGA Page 23 TRAINING MANUAL
SPIN ONLY
The SPIN ONLY cycle is not shown on the console. To engage SPIN ONLY, Press POWER
and then SPIN SPEED. The COTTON / NORMAL LED will light. The machine will default
to a 0:13 minute cycle on high speed unless EXTRA HIGH SPIN is selected, which will
increase cycle time to 0:17. The drain pump is energized as required during the spin
cycle to exhaust all the water extracted from the load.
PRE-WASH
Pre-wash adds a pre-wash cycle before the main wash cycle. Pre-wash fills the tub and
dispenses what was put into the pre-wash detergent compartment. After filling and
washing, the pre-wash water is pumped out and the main wash cycle begins.
STAIN CYCLE
The stain cycle adds time to the wash cycle and increases the temperature of the wash
water for increased cleaning performance.
SPINSENSE
™
SPINSENSE
™
is a cycle that reduces the spin speed after sensing an unbalanced load. To
engage the SPINSENSE
™
, press POWER and select a cycle. Press and hold the
SPINSENSE
™
(Rinse+Spin) button. SPINSENSE
™
will remain engaged until it is
disengaged by the user. Turning the machine off or losing power will not disable
SPINSENSE
™
.
CHILD LOCK
CHILD LOCK is designed to disable the control pad after the cycle is started. To activate
the CHILD LOCK after the cycle has begun, press and hold CHILD LOCK (Delay Start)
until CL shows on the display. All controls will be disabled until the end of the cycle.
CUSTOM PROGRAM
The CUSTOM PROGRAM button allows the customer to set a commonly used program
for personal convenience. For example, he may prefer the COTTON/NORMAL cycle but
with a HOT WASH instead WARM, EXTRA HIGH SPIN instead of the regular spin, and a
LIGHT SOIL level to shorten the cycle time. By programming these selections to the
CUSTOM PROGRAM button, the customer can simply press it every time he wants to
use this particular cycle. To program the CUSTOM PROGRAM BUTTON, press POWER.
To Next Page
Loading...
