TRAINING MANUAL WM0742HGA
WM0742HGA Page 35 TRAINING MANUAL
DISASSEMBLY and REPAIR, continued
FRONT COVER
Remove the control panel and top cover
as shown on page 32 and set them aside.
Open the filter and drain cover.
Remove the screw securing the cover and
pry the cover out with a screwdriver or
putty knife. Be careful to avoid damaging
the rim of the opening.
With the filter cover removed, remove the
two screws that secure the base of the
front cover to the machine frame.
Remove the door gasket using the special
tool 383EER4001A to remove the spring
clamp.
After removing the door gasket, you can
reach inside the cabinet and unplug the
electrical connector to the door switch.
If you are replacing the door switch, you
can do it without any disassembly other
than the door gasket. Remove the two
screws that hold the switch in place, pull it
out through the opening, and replace it.
To Next Page
Loading...
