TRAINING MANUAL WM0742HGA
WM0742HGA Page 37 TRAINING MANUAL
DISASSEMBLY and REPAIR, continued
PUMPS and FILTER HOUSING
Remove the front cabinet. (See page 36.)
Drain the water from the sump.
Remove the clamps and hoses.
Remove two screws and push the pump
backward and up.
Press down the plastic tab on the base to
slide the pump assembly backward.
This tab is for the convenience of the
workers in the assembly plant. It holds the
pump in place while the machine is
assembled. If you break it, don’t worry
about it. The slot in the base and the two
screws on the front will hold the pump
securely in place.
You can tilt the pump in either direction
to remove/replace the individual pumps
without having to remove the tub.
Have a towel handy to catch the spillage.
To Next Page
Loading...
