LG WM0742H Series - Test Mode

TRAINING MANUAL WM0742HGA
WM0742HGA Page 53 TRAINING MANUAL
TEST MODE
The steam washer must be empty and off to enter the test mode.
1. Press and hold SPIN SPEED and SOIL LEVEL.
2. Press POWER. The buzzer will sound twice.
3. Press START/PAUSE to cycle through the test modes. (See chart, below.)
Number of times
Start/Pause pressed
Event Display
None All lamps on / door locked 18:84
1 Drain pump/Tumble clockwise
rpm
1
(42 ~ 50)
2 Spin – Low speed
rpm
1
(55 ~ 65)
1
3 Spin – High Speed
rpm
1
(105 ~ 125)
1
4 Pre-wash valve (Cold)
Water level freq. (25 ~ 65)
2
5 Main wash valve (Cold)
Water level freq. (25 ~ 65)
2
6 Main wash valve (Hot)
Water level freq. (25 ~ 65)
2
7 Softener valve (Cold)
Water level freq. (25 ~ 65)
2
8 Bleach valve (Cold) Water level freq. (25 ~ 65)
2
9 Steam valve (Cold) Water level freq. (25 ~ 65)
2
10 Tumble counterclockwise
rpm
1
(42 ~ 50)
11 Tub heater (1.2 seconds)
Water temperature (tub) °C
3
12 Circulation pump
Water level freq. (25 ~ 65)
2
13 Drain pump
Water level freq. (25 ~ 65)
2
14 Water level sensor ( steam)
Water level freq. (31 ~ 246)
2
15 Steam generator heater
Water temperature (TSG) °C
3
16 Off
Notes: 1. Insert a zero at the end of the displayed numbers to determine the actual
rpm. 62 indicates 620 rpm; 115 indicates 1,150 rpm.
2. Insert a 2 at the beginning of the displayed number to determine the
actual water level frequency. 65 indicates 265 or 26.5 KHz.
3. Temperatures are displayed in degrees Celsius.
The following button combinations allow access to these sensor readings:
PREWASH and CUSTOM Steam generator temperature in °C
WASH/RINSE and CUSTOM Tub water temperature in °C
SOIL LEVEL and CUSTOM Water level (displayed as a frequency)
SPIN SPEED and CUSTOM Drum rpm speed (see note above)