TRAINING MANUAL WM0742HGA
WM0742HGA Page 90 TRAINING MANUAL
Process Technical Information, continued
9. Rinse Spin * The water remaining in the load is extracted by centrifugal
force while the drum is spun at the selected speed.
10. Remaining Spin * The power to the motor is cut off and the drum continues
to spin by inertia until it stops.
* This process overlaps the next process, rinsing.
11. Rinse Water
Supply
* Cold water is supplied to the drum for rinsing the load.
12. Rinse * After the water is supplied, the drum is rotated clockwise
and counterclockwise to rinse the load.
13. Final
Draining
* After the rinse cycle is completed, the power to the motor
is cut off and the drum continues to spin by inertia until
it stops.
* If RINSE HOLD is selected, the drum is not drained after the
rinse cycle is completed.
14. Detangling * At the end of the cycle, the power to the motor is cut off
and the drum continues to spin by inertia until it stops
turning. Then it is rotated slowly, alternately counter-
clockwise and clockwise, several times in each direction to
help untangle the load.
15. End of Cycle * At the end of the cycle, the display shows END for
8 seconds. The machine reverts to the STANDBY mode,
and the door is unlocked.
To Next Page
Loading...
