LG WM2101H Series - How to Use the Washer; Basic Controls: Power, Cycles, Start;Pause

NORMAL
COTTON/TOWELS•
SANITARY •
y
J
,9
PERM. PRESS
DELICATES
HANDWASH
DELAY
/WOOL_
• SPEEDWASH WAT£RPLUS
Cycle Selector Knob
EXTRARINSE
*PR_SS_HeLO3S_
_ HOT/COLD C HIGH ( Y
-)WARMhNARM C_ MEDIUM NORMAL _ LOW QUICKCYCLE
WARM/COLD C" LOW - T STAIN CYCLE
_COLD/COLD O NOSPIN - LIGHT _ OFF _ TUBCLEAN
OPTION
1. Power
• Use this button to turn the Power On/Off.
2. Cycles
• Rotate the Cycle selector knob to select cycle
designed for different types of fabric and soil
levels.
• Each cycle has a preset Water Temperature, Spin
Speed, Soil Level, and Option (See page 13).
• The preset settings can be changed anytime
before Start.
NOTE: This front load washer requires longer cycle time
and gets clothes much cleaner, yet is more gentle
on the fabrics, than top load washers. Washing
time can be reduced significantly for small loads
or lightly soiled loads by selecting Speed Wash
cycle and setting the Soil Level button at Light.
3. Start/Pause
• Use this button to start/stop the washer.
NOTE: If you do not press the StartlPause button
within 4 minutes of selecting a cycle, the washer
automatically turns off.
4. Delay Wash
• Allows the start of any cycle to be delayed for
1~12 hours.
• Choose the wash cycle for your load, and then
press the Delay Wash button once for one hour or
press the button again to increase the delay wash
time up to 12 hours in one hour increments.
5. Water Plus
• Adds extra water to the wash and rinse cycles for
superior results.
m
6. SPINSENSE TM
•SPINSENSE TM can be used when there is a vibration
problem, especially on wood floor installations.
•To operate SPINSENSE TM press and hold the Water
Plus button for 3 seconds when the washing machine
is running on any cycle.
•When SPINSENSE Mhas been selected, the Spin
Speed button light will blink on and off continually to
indicate that the SPINSENSE TM function has been
selected.
• Push and hold the Water Plus button again for 3
seconds to cancel SPINSENSE TM.
•Once SPINSENSE TM has been selected, if will continue
to function even if interrupted by a power failure.
• 'SPINSENSE' option cannot be selected during the
spinning cycle.
7. Extra Rinse
14
• This option provides an additional rinse.
• Use this option to ensure the removal of detergent
or bleach residue from garments.