WM2277 WASHER PAGE 52 of 84 TRAINING MANUAL
7. Open the door.
8. Remove the clamp using
special tool 383EER4001A.
Leave the gasket attached to
the tub at this time.
9. Lean the cabinet front forward,
being careful to avoid breaking
the glass. The door is HEAVY.
10. Disconnect the door switch
connector. (Remember to
replace it upon reassembly.)
(See page 52.)
11. Lift the door and front cover off
the cabinet base as an
assembly. Lay it face down on
a blanket or some other
protective surface.
12. Separate the spring retaining
clip so you can lift the tub out of
the cabinet.
Be careful and make sure you
have disconnected every wire
and hose to avoid damage or
complications.
To Next Page
Loading...
