WM2277 WASHER PAGE 55 of 84 TRAINING MANUAL
DISASSEMBLY/REPAIR (Pump)
1. Remove the front cabinet.
(See page 46.)
2. Drain the water from the sump.
(See page 9.)
3. Remove the clamps and hoses.
4. Remove two screws and push
the pump backward and up.
5. Press down the plastic tab on
the base behind the pump to
slide the pump assembly
backward.
You don’t have to worry if you
break the tab. It is there for the
assembly process in the
factory. A screw holds the
pump housing in place when
the washer is assembled.
Just slide it into the bracket.
6. You can tilt the pump in either
direction to remove/replace the
individual pumps without
having to remove the tub.
Have a towel handy to catch
the spillage.
To Next Page
Loading...
