WM2277 WASHER PAGE 59 of 84 TRAINING MANUAL
DISASSEMBLY/REPAIR (Motor)
For technical information concerning
the direct drive DC motor, refer to
page 25.)
1. Remove the back cover.
2. Remove the large bolt in the
center shaft. (Your helper can
hold the inside of the drum.)
3. Pull the rotor off the shaft.
4. Remove two screws from the
tub bracket.
5. Remove six bolts on the stator.
6. Unplug two connectors on the
stator.
7. Pull the stator off the shaft.
8. When re-installing, the clamps
and the ground screw must be
installed and the connectors
pressed into place before the
rotor is bolted onto the shaft.
To Next Page
Loading...
