WM2496H*M Page 22 of 58 TRAINING MANUAL
TEST MODE
The WM2496 washer must be empty and off to enter the test mode.
1. Press and hold NO SPIN and LIGHT SOIL LEVEL.
2. Press POWER.
3. Press START/PAUSE to cycle through the test modes. (See chart.)
CHECK SUMS
WM2277H* 1F:81 WM2077CW 1F:82
WM2177H* 1F:81 WM2677H*M 1F:61
CHECK THE WATER LEVEL FREQUENCY
The numbers shown in the display indicate the water level frequency.
Divide the number in the display by 10 to get the reading in kH
z
.
ex. Display is 241, so the reading is 24.1 kH
z
.
To Next Page
Loading...
