WM2496H*M Page 37 of 58 TRAINING MANUAL
DISASSEMBLY/REPAIR (Control Panel)
1. Remove two screws on the back
of the top plate.
2. Pull the top plate backward and
lift, as shown.
(control panel not exactly as pictured)
3. Remove the detergent drawer.
4. Remove two screws behind the
detergent drawer.
5. Disconnect the connector for
the Display PWB.
6. Remove one screw from the
corner of the control panel.
7. Lift the top away from the
support rail and pull the control
panel up and away to remove.
(control panel not exactly as pictured)
8. Remove eight screws to
separate the control panel
and PWB.
9. Reassembly is the reverse of
these steps.
To Next Page
Loading...
