WM2496H*M Page 38 of 58 TRAINING MANUAL
DISASSEMBLY/REPAIR (Main Board)
Often, you can diagnose a failed part by removing its connector on the main
board and connecting the tester to the leads in the connector. (See page 51.)
1. Disconnect the POWER
connector and the Water Level
Sensor Switch.
2. Remove the protective cover.
Press the plastic tabs out of the
way to remove the cover. The
main board is potted, so no
repairs to it are possible. You
can remove connectors to test
various components without
having to disassemble the
washer at this point. To
continue, remove the pressure
sensor and wire holders on
the cover and set it aside.
3. Disconnect the connectors on
the main board. They are all
different, keyed, and color-
coded to prevent incorrect
connection.
4. Pull the wires out of the way.
5. Remove one screw on the back
of the washer to release the
main board housing.
6. Remove the main board by
sliding it to the right and lifting
it up. Press it to the back and
left to replace it.
To Next Page
Loading...
