WM2496H*M Page 39 of 58 TRAINING MANUAL
DISASSEMBLY/REPAIR (Dispenser)
(control panel not exactly as pictured)
1. Remove the top plate.
(See page 37.)
2. Remove the dispenser drawer.
3. Remove two screws to release
the dispenser.
4. Loosen the clamp on the large
hose that runs from the
dispenser to the drum.
Have an old towel handy to stuff
under the dispenser to soak up
any spillage.
5. Disconnect the connector from
the solenoid. Make a note of the
color codes and connections.
#1 Blue; yellow and black wires
#2 White; white and black wires
#3 Blue; gray and black wires
#4 Red; blue and black wires (hot)
6. Remove two screws from the
back of the cabinet
DISASSEMBLY/REPAIR (Noise Filter)
1. Remove the connectors from the
noise filter.
2. Remove the screw from the top
bracket.
To Next Page
Loading...
